I have rasberry pi 4 8GB. Using PINN I installed both RPi OS and Lineage OS 20 android tv.
I noticed that the monitor (connected through HDMI) goes randomly on and off. It happens in both OS.
It seems more frequent when doing some operations with software.
Any suggestions ?
Here is my config.txt (default one)
I noticed that the monitor (connected through HDMI) goes randomly on and off. It happens in both OS.
It seems more frequent when doing some operations with software.
Any suggestions ?
Here is my config.txt (default one)
Code:
# Uncomment some or all of these to enable the optional hardware interfaces#dtparam=i2c_arm=on#dtparam=i2s=on#dtparam=spi=on# Enable audio (loads snd_bcm2835)dtparam=audio=on# Additional overlays and parameters are documented# /boot/firmware/overlays/README# Automatically load overlays for detected camerascamera_auto_detect=1# Automatically load overlays for detected DSI displaysdisplay_auto_detect=1# Automatically load initramfs files, if foundauto_initramfs=1# Enable DRM VC4 V3D driverdtoverlay=vc4-kms-v3dmax_framebuffers=2# Don't have the firmware create an initial video= setting in cmdline.txt.# Use the kernel's default instead.disable_fw_kms_setup=1# Disable compensation for displays with overscandisable_overscan=1# Run as fast as firmware / board allowsarm_boost=1[cm4]# Enable host mode on the 2711 built-in XHCI USB controller.# This line should be removed if the legacy DWC2 controller is required# (e.g. for USB device mode) or if USB support is not required.otg_mode=1[all]# NOOBS Auto-generated Settings:Statistics: Posted by semola_ — Mon Jan 08, 2024 1:49 pm