Is there a resolution to this issue?
I had been running 32-bit bullseye and klipper for my 3d printer using a 3B+ for years with no issues. I have recently been forced to upgrade to 64-bit and so went with bookworm. The pi gets stuck on boot 3 times of 5 and seems worse at times! I cant see anything in the logs and couldn't work it out until I found this thread. Driving me crazy as I start the printer often.![:(]( "Sad")
I had been running 32-bit bullseye and klipper for my 3d printer using a 3B+ for years with no issues. I have recently been forced to upgrade to 64-bit and so went with bookworm. The pi gets stuck on boot 3 times of 5 and seems worse at times! I cant see anything in the logs and couldn't work it out until I found this thread. Driving me crazy as I start the printer often.
Statistics: Posted by kens96 — Fri Jan 31, 2025 3:38 pm