I've tried RPi Imager 2.0.3, 2.0.2 and 1.9.6 (assuming it was that).
I've got a RPi3B with an official touchscreen (original one).
I'm trying to load RaspiOS Trixie 64bit normal (with wayland and the normal screen stuff).
The OS boots OK (with all three imager versions).
It gets the "Welcome to the Raspberry Pi Desktop" splash screen "Powered by Raspberry Pi OS (64-bit)" logo.
Then it hangs in systemd-hostnamed.service.
Where do we go from here?
I've pressed CTRL+F1 and it blanks the screen. I've pressed CTRL+R and it goes back to the RPi logo (minus the hanging service name).
I can't get a command line screen prompt.
I can't get past the logo.
I can't ssh in from my network.
I've not tried connecting an HDMI, that's my next test.
I've got a RPi3B with an official touchscreen (original one).
I'm trying to load RaspiOS Trixie 64bit normal (with wayland and the normal screen stuff).
The OS boots OK (with all three imager versions).
It gets the "Welcome to the Raspberry Pi Desktop" splash screen "Powered by Raspberry Pi OS (64-bit)" logo.
Then it hangs in systemd-hostnamed.service.
Where do we go from here?
I've pressed CTRL+F1 and it blanks the screen. I've pressed CTRL+R and it goes back to the RPi logo (minus the hanging service name).
I can't get a command line screen prompt.
I can't get past the logo.
I can't ssh in from my network.
I've not tried connecting an HDMI, that's my next test.
Statistics: Posted by DougieLawson — Tue Dec 23, 2025 8:46 pm